User`s manual

3-1
CHAPTER 3
GETTING START
There are two methods to control the WireSpan 3000/3000E ,one is
using the front panel LCD controller; the other is using the console
port on the rear panel.
The Front Panel LCD Controller
The front panel LCD controller consists of the LCD display and front
panel switches. The menu tree consists of several categories. Each
category has several options (STATUS, CONFIGURE, DIAGNOSTIC,
etc.) Many of these options are configurable, while others indicate
the device status. Most options contain several selectable settings.
Each of the settings affects various operating characteristics. Using
the front panel control keys, you can easily access the options and
settings under each category.
The following sections describe the major options of the menu tree.
Please refer to Appendix C for detail structure of the menu tree.
Main Menu
The main menu shows up right after power on selftest. The main
menu displays the current status of the device. The main menu
shows as the following:
HTU-R 2E1 1 1 6 8
120 OHM HDB3
HTU-C or HTU-R: To indicate current terminal type is local (HTU-C)
or remote (HTU-R).
2E1: To indicate two-pair E1 operation.
1168: date rate on per pair HDSL loop.