User manual

Atrie DB-120 WL User Manual
Page 5 / 25
2 INTRODUCTION
2.1 INTERFACE INTRODUCTION
2.1.1 INDICATOR AND INTERFACE
Table 2.1
Item Name Introduction
POWER Red, Indicates the status of the power connection.
WAN Yellow, Shows DSL line status.
PPPoE Green, Indicates the status of internal PPPoE.
Indicator
LAN Green, Indicates the status of Ethernet interface.
LINE Connected with phone line or "ADSL" port of the splitter.
ETHERNET
To be connected to a PC network card by a straight-through network cable,
also can use a crossover cable to connect to Hub, Switch or Router.
POWER Power interface, Connect with power adapter.
RST
The RST button will set the Gateway to its factory default setting and
reset the Gateway. You may need to place the Gateway into its factory
defaults if the configuration is changed, you loose the ability to interface to
the Gateway via the web interface, or following a software upgrade, and you
loose the ability to interface to the Gateway. To reset the Gateway, simply
press the reset button for more than 10 seconds. The Gateway will be reset
to its factory defaults and after about 30 seconds the Gateway will become
operational again.
Interface
SWITCH To turn on / off the power.
2.1.2 SPLITTER SPEC
Table 2.2
Interface Introduction
LINE Connected with telephone line.
ADSL
Connect with the LINE port of the Gateway by
telephone line provided.
PHONE Connect with telephone.
2.2 HARDWARE CONNECTION
Figure 2.1