User manual

Atrie DB108 WL User Manual
- 8 -
PVC 4 14 24
PVC 5 0 100
The default configuration is “1483 Bridged LLC” encapsulation，If you only want this mode，there is no need to
modify it. But if you want the routed mode（for example PPPoE、PPPoA、1483routed），the other PVC must be
closed in advance. Otherwise you must set the “NAT” to “Dynamic NAPT” to realize the same function (Refer
to 3.2 for detail.).
Steps are shown as following (close the PVC1) ：
1． click“wan”，select the “Virtual Circuit 1” on the right frame
2． click“Submit”.
3． Set the “enabled” item to “No” on the top.
4． click“Submit”again to activate the setting.The result is shown as Figure2.5
5． Closing the rest is the similar.
6．
Click “Save Settings” anchor in the left frame. Click “Submit” to save all settings. Device will restart
automatically and run with new parameters.
Figure 2.5