User manual

Atrie DB108 WL User Manual
- 7 -
Figure 2.4
2． SSID (Service Set Identifier): the mobile users cannot access WLAN until setting their SSID as the same
value of the modem. The SSID value of the modem is “default”
3． Channel：to denote the different frequency of wireless signals whose value is from 1 to 13. The default
value is”6”. If there are more than one APs located in the same area, each of them must works at different
channels to reduce interference. For Example: Three APs are install in the same place, the AP’s channel
should be 1,6 and 11 respectively.
4． Security: to enable or disable WEP Encryption.
Key length: 64 bits or 128 bits；
Key1-4: up to four keys that are in form of hex digitals could be set. Mobile users can’t access the AP if
they haven’t set the same key as AP when WEP encryption mode is enabled.
5． After all parameters are successfully set, click the “submit” button on the bottom of the page.
6． Then click “Save setting” in the left frame and click “Submit” button in the new page to save the
parameters which is shown as Figure2.3. The modem will restart automatically with the new parameters.
2.3.6 DEFAULT CONFIGURATION
The device have pre-configuration VPI / VCI which is shown as table 1：
Table 1
VPI VCI
PVC 0 0 32
PVC 1 8 35
PVC 2 0 35
PVC 3 8 81