User manual

Atrie DB108 WL User Manual
- 6 -
2.3.4 ADSL MODEM WORKING MODE CONFIGURATION
1． According to the different protocols, Users set ADSL Modem as bellows:
Table 2.2
PAGE ITEM PPPoE PPPoA 1483 BRIDGE
CONNECT
1483
ROUTING
1577
PRIVATE
LINE
VPI/VCI
√ √ √ √ √
STATIC IP
ADDRESS
× × × √ √
SUBNET MASK
× × × √ √
ENCAPSULATION
FORMAT
PPPoE PPPoA 1483 Bridged IP 1483 Bridged IP Classical IP
over ATM
BRIDGE Disabled Disabled Enabled Disabled Disabled
USERNAME
√ √ × × ×
PASSWORD
√ √ × × ×
WAN
DEFUALT
GATEWAY
× × × √ √
NAT NAT NAPT NAPT Disabled NAPT NAPT
CHAPTER 3.3 3.3 3.1 3.2 3.2
NOTE：√ means to configure according to ADSL service provider’s instructed value
× means that don’t modify it .
PPPoE can also be realized via third party dial software.
2． Click “Submit” button on the bottom of page to save the parameters；
3． Click “Save setting” in the left frame to save configuration which is shown as Figure2.3.
Figure 2.3
5. Click “Submit” button to save the parameters, then device will restart automatically and run on the new
parameters.
2.3.5 Wireless working mode configuration
1． Click the “Wireless” anchor in the left frame. Wireless configuration page will be popped up as figure2.4.