User manual

Atrie DB108 WL User Manual
- 10 -
Click “NAT” anchor in the left frame and Set “NAT” item to“Disabled” in the right frame. Finally click
“Submit” to save the configuration, which is shown as Figure 3.2.
Figure 3.2
Click “Save Settings” button in the left frame and Click “Submit” in the right frame to save all above
settings, which is shown as Figure 2.3. Then modem will restart automatically and run with new parameters.
3.2
STATIC ROUTING CONFIGURATION（RFC1483ROUTING/RFC1577）
1． WAN SETTINGS
z Click “Wan” anchor in the left frame and select the virtual circuit in the left frame. Click “submit” button.
z Set “Enabled” to “Ye s”；
z Input the value of VPI and VCI (For example VPI=0/VCI=32)；
z Set“Static IP Address”and “Subnet Mask”(For example set IP Address to202.1.136.254 and set Subnet
Mask to 255.255.255.0)
z To 1483 routed mode，select “1483 Bridged IP LLC” or “1483 Bridged IP VC－MUX” in
“encapsulation ” item (certain value need to be provided by DSL provider);
z To 1577 private line mode，select “Classical IP over ATM” in “encapsulation”；
z Select “Disabled” in “Bridge” item；
z Input gateway IP Address in “default gateway” filed (For example set 202.1.136.1 as gateway address)
z Click “Submit” button on the bottom of the page to save the parameters.
z The result is shown as figure 3.3.