User guide

ATouch User Guide
32
touchscreen’s tail away from display’s inverter and insulate against
the display device; Second, make sure that the touchscreen controller
is insulated, and keep it away from the display’s inverter.
Cursor shakes before the touchscreen controller is installed in
display.
x Maybe the touch sensor’s tail contacts the display’s inverter. Check if
the tail’s position is changeable. If it is hard to change tail’s position,
then stick thick insulating tape around the tail or stick a copper slice
with insulation on one side and electric conduction on the other side
to insulate the tail from the inverter.
Touch position is not accurate.
x Use the Calibration function of the ATouch Control Center program
to re-align.
x If the touch position is not accurate after the calibration, please check
whether the touchscreen driver you use is the newest version.
Chapter 5 Contact
For any question, please contact with your distributor or
contact with A Touch Technical Support Dept.:
[e-mail]