User manual

User manual Version 1.0
SW5002 Wireless Serial Server
Copyright © 2007 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan
- 49 -
Installation
Make sure you have turned off all anti-virus software before beginning the installation. Run Vcom.exe
program included in the CD to install Virtual COM for your operating system.
In the end of the installation, please select one or two COM ports to become the Virtual COM ports.
Uninstalling
 From Windows Start menu, select Setting\ Control Panel\ Add/Remove Programs.
 Select Serial IP for in the list of installed software.
 Click the Add/Remove button to remove the program, or From Windows Start menu select
Programs, Serial IP click Uninstall Serial IP to remove the program.
A.3. Virtual COM Communication
Enable Virtual COM on SW5002 by web interface
From web browser access to SW5002 by typing its IP address, click on “Serial” link to access Serial
page, on the top half of the page click on “TCP Server” and enable Virtual COM by putting a check in
front of the “Enable” checkbox, then type in the local port number in the “Local Port” field as indicated
in the following screen.
Fig 68. Enable Virtual COM Mode by Web page
Enable Virtual COM on SW5002 by Telnet
User may also enable Virtual COM through telnet by setting Serial as a TCP server, and enter the
local port number for Serial, then enable virtual COM as shown in the following procedure: