User manual

User manual Version 1.0
SW5002 Wireless Serial Server
Copyright © 2007 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan
- 34 -
6.2.3. SNMP Settings
Operation: [Main][2 Networking][3 SNMP Settings]
Select “3” from “Input choice (0~3) and enter on Networking page:” to enter SNMP Settings page.
User can enable/disable SNMP, and set network identification information on SNMP Settings page.
The changes will not become effective until SW5002 is restarted
SW5002 basically supports get/set SNMP parameters, these are SysName (System Name),
SysLocation (System Location) and SysContact (System Contact). These fields will response and
supply basic system information from standard SNMP query. User can set the SNMP system
parameters by enter the corresponding menus and values. For example, enter 2 for changing the
SysName then enter the desired name.
Fig 44. SNMP Settings by Telnet
6.3. Wireless Configuration
Operation: [Main]  [3 Wireless Settings]
Select “3” from “Input choice (0~6) and enter:” the following screen shall appear (Fig. 45).
User can configure wireless IP, Netmask, Gateway, IP mode, and Region by enter the
corresponding menu and corresponding values.
Fig 45. Configure Wireless Settings by Telnet