User manual

User manual Version 1.0

SW5002 Wireless Serial Server

- 5 -

3.2. IP Assignment

3.2.1. Configure IP by Monitor.exe utility

Use Monitor.exe configuration utility that comes with product CD or diskette to configure the network

parameters. For more details, please refer to Appendix B1.

Find new device and IP assignment

 Use Monitor.exe for finding new device IP address, get device’s current IP from table list

 Re-assigned IP, network mask and gateway if need with Monitor.exe.

 User can configure User ID, Password and Host Name with Monitor.exe utility.

Fig 2. IP settings for Monitor.exe tool

 Note: All settings were NOT changed if user ID or password was incorrect.

If there is more than one device using the same IP address in same Subnet. User has to correct

mapping between MAC address & IP address by ARP commands.

ARP commands

ARP (address resolution protocol) commands can be used to assign a static IP address on SW5002

using its hardware MAC (media access control) address. The MAC address"0060E9-xxxxxx" is

printed on the rear side of SW5002. The following figure shows how to use ARP command on

MS-DOS command prompt window.

Example: Set IP 10.0.50.101 to MAC address 00-60-E9-00-79-F8.

Fig 3. Map IP address to MAC address by ARP Command