User`s manual

User manual Version 1.1

SE5408/SE5416 Multi-port

Serial Server

- 10 -

SE5016:COM1 – COM16

SE5008:COM1– COM8

RS232, 9600 bps, 8 data bits, None Parity bit, 1 stop bit, None Flow

Control, Buffer Disabled,

Packet Delimiter timer: 1ms

Serial Port 1 –16

Type: TCP Server, Local port 4660 - 4675, Filter = 0.0.0.0,

Virtual COM disabled (for SE5008: Port 1 - 8, TCP local port 4660 -

4667)

SNMP

SysName of SNMP 0060E9-XXXXXX

SysLocation of SNMP Location

SysContact of SNMP Contact

SNMP Enable

Read Community Public

Write Community Private

SNMP Trap Server 0.0.0.0

Table 1. Factory Default Settings

NOTE: One may press the “Reset” button on the front panel with a paper clip for 5 seconds to

restore the server to the factory default settings.

Device IP Address Assignments

Configure using SerialManager

First, please install our configuration utility program SerialManager that comes with Product CD. To find

our serial server devices on your network, press “Scan”, and the list of the devices is shown in the main

window. To configure each device, click the selected device (default IP: 10.0.50.100) to login with the

default username and password. After successful login, click “Configuration=> Network Setting” to pop up

the following dialogue box:

Fig 3. Network settings with SerialManager

You may proceed to change the IP address to avoid any IP address conflict with other hosts on your LAN

network or to connect the device to your existing LAN. Please consult your system administrator if you do