User`s manual

User manual Version 1.3

SW5002 Wireless Serial Server

- 4 -

3. Software Setup

Now the SW5002 hardware is installed and power is on, network IP configuration will be set in this

section.

3.1. Default Settings

The SW5002 has two IP addresses one for Ethernet interface and another one for wireless network

interface. These default settings are shown from under information

Default IP addresses

Interface Device IP Subnet mask Gateway IP

LAN port 10.0.0.50.100 255.255.0.0 10.0.0.254

WLAN Port 192.168.1.1 255.255.255.0 192.168.1.254

The other default settings of SW5002 are shown in the following table

Property Default Value

Ethernet Port

IP Address 10.0.50.100

Gateway 10.0.0.254

Subnet Mask 255.255.0.0

WLAN Port

IP Address 192.168.1.100

Gateway 192.168.1.254

Subnet Mask 255.255.255.0

Securit

User Name

Admin

Password

Null (Leave it blank)

Serial

COM 9600/None/ 8/1,No flow control, packet delimiter disabled

Link Mode TCP Server, Listen port 4660/4661,No Filter, Virtual COM disabled

SNMP

SysName of SNMP Name

SysLocation of SNMP Location

SysContact of SNMP Contact

Table 1. Default settings of the SW5002 device

 NOTE: Press reset button for 5 seconds then release the button to restart SW5002 to the default

settings.

 Waring: Please avoid setting LAN and WLAN IP address in the same subnet, that may make

unexpect networking problem.