User`s manual

User manual Version 1.3

SW5002 Wireless Serial Server

- 52 -

Running Serial to IP for program on PC

On Window Start Menu, go to\program\Serial/IP\Control panel\, The “Serial to IP for Control Panel”

window shall appear. Then select the serial port.

Fig 71. Detail setting from Serial/IP

On the right of the panel is a sample for COM 4 settings. On the left is the list of the COM ports that have

been selected (on Select Ports window) for use by the Virtual COM Redirector. Change the list by clicking

the Select Ports button.

Each COM port has its own settings. When click on a COM port, the Control Panel changes to reflect that

the selected port.

 Note: COM port changes become effective immediately.

Configure Virtual COM Ports

Serial/IP COM port can be changed as follows:

 Select a COM port on the list.

 On IP Address of Server, enter SW5002 IP address.

 On Port Number, enter the TCP port number of the SW5002.

 On Server Credentials, the default is No Login Required. If the SW5002 does require login by

the Virtual COM Redirector, the Virtual COM Redirector must provide a username and/or

password every time an application tries to access the SW5002.

 Click the Configuration Wizard button and then click the Start button that shall appear on the

wizard window. This step verifies that the Virtual COM Redirector communicates with the SW5002.

If Log display does not show errors, click Use Settings, return to the Control Panel

 Settings on the Connection Protocol must match the TCP/IP protocol supported by the

SW5002. The Configuration Wizard is capable of determining the correct settings.

 On COM Port Options, the settings must match the COM port behavior expected by the PC

application. The Configuration Wizard will recommend such settings.