User`s manual

User manual Version 1.3
SW5002 Wireless Serial Server
Copyright © 2010 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan
- 36 -
6.2.3. SNMP Settings
Operation: [Main]Æ[2 Networking]Æ[3 SNMP Settings]
Select “3” from “Input choice (0~3) and enter on Networking page:” to enter SNMP Settings page. User
can enable/disable SNMP, and set network identification information on SNMP Settings page. The
changes will not become effective until SW5002 is restarted
SW5002 basically supports get/set SNMP parameters, these are SysName (System Name), SysLocation
(System Location) and SysContact (System Contact). These fields will response and supply basic system
information from standard SNMP query. User can set the SNMP system parameters by enter the
corresponding menus and values. For example, enter 2 for changing the SysName then enter the desired
name.
Fig 44. SNMP Settings by Telnet
6.3. Wireless Configuration
Operation: [Main] Æ [3 Wireless Settings]
Select “3” from “Input choice (0~6) and enter:” the following screen shall appear (Fig. 45).
User can configure wireless IP, Netmask, Gateway, IP mode, and Region by enter the corresponding
menu and corresponding values.
Fig 45. Configure Wireless Settings by Telnet