User`s manual

User manual Version 1.3
SW5002 Wireless Serial Server
Copyright © 2010 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan
- 5 -
3.2. IP Assignment
3.2.1. Configure IP by SerialManager Utility
Use SerialManager configuration utility that comes with product CD or diskette to configure the network
parameters. For more details, please refer to Appendix B1.
Find new device and IP assignment
 Use SerialManager Utility for finding new device IP address, get device’s current IP from table
list
 Re-assigned IP, network mask and gateway if need with SerialManager Utility.
 User can configure User ID, Password and Host Name with SerialManager Utility.
Fig 2. IP settings for SerialManager Utility tool
 Note: All settings were NOT changed if user ID or password was incorrect.
If there is more than one device using the same IP address in same Subnet. User has to correct mapping
between MAC address & IP address by ARP commands.
ARP commands
ARP (address resolution protocol) commands can be used to assign a static IP address on SW5002 using
its hardware MAC (media access control) address. The MAC address"0060E9-xxxxxx" is printed on the rear
side of SW5002. The following figure shows how to use ARP command on MS-DOS command prompt
window.
Example: Set IP 10.0.50.101 to MAC address 00-60-E9-00-79-F8.
Fig 3. Map IP address to MAC address by ARP Command