Installation guide

Sms4Domino Help
- 67 -
IP Modem Gateway documents
IP Modem Gateway documentsIP Modem Gateway documents
IP Modem Gateway documents
IP modems are serial modems that are connected via a serial-to-ethernet convertor. Some modems
may have a build-in convertor, others require a separate box.
Sms4Domino sends and receives the same AT commands but uses TCP/IP to communicate with the
modem.
Before configuring this kind of modem gateway document you should have tested the modem and
configured the serial-to-ethernet convertor.
Specific settings for IP Modem Gateway
Directions: specify if the modem is used for sending SMS messages (outbound) and/or

receiving SMS messages (inbound)
IP address: the IP address of the serial-to-ethernet convertor. It must be possible to ping

this address from the machine where Sms4Domino will be running.
IP port: the port number that has been configured in the serial-to-ethernet convertor.

When issuing a telnet command (in binary mode) to the <ip address> <port> number you
should be able to send AT commands and receive the responses.
Manufacturer - model: communication between the computer and the modem is based

on AT-commands. Most modems are using the same set of AT commands. Some
modems deviate from the standard. Specify Generic if your modem is not listed.
PIN code: the PIN code of the SIM card in the modem. Sms4Domino may lock the card

if a wrong Pin code is specified. Sms4Domino has no tools to reset the Pin code.