Installation guide

Sms4Domino Help
- 56 -
between commands
for the same target
instance
minimum delay between two commands for the same Sms
4
Domino remote
instance is specified.
Default value: 10 seconds.
Console commands When the current Sms4Domino instance x performs least cost routing to
another Instance y (target instance) all listed console commands will be
issued on the Domino server that holds the configuration database of the
current instance.
This is a multi-valued field. Separate values by newline .
Each line is formatted as
Target Instance ID%%Console command
E.g.
Instancey/Sms4Domino%%replicate Instancey/Sms4Domino
sms4domino\config.nsf
Instancez/Sms4Domino%%replicate Instancez/Sms4Domino
sms4domino\config.nsf
There could be zero, one or more commands for any target Instance ID
Low priority time ranges Low priority SMS messages are sent after high and normal priority
messages but may be sent at any time during the day.
However, low priority messages are only given to the SMS server during
the specified time ranges.
Each time range is formatted as starttime - end time .
Multiple ranges may be separated by new line or by comma.
The end time must be greater than the start time.
If no value is specified low priority messages are sent like normal SMS
messages.
E.g.
00:01 - 06:00, 20:00 - 23:59
Accounting records Each time an SMS message has been transmitted or received an
accounting record may be generated. Accounting records may be used for
internal billing processes and give management a detailed view on the use
of the server.
The detailed outbound accounting records are further aggregated into
aggregated accounting documents. These aggregated figures may be
used (not yet implemented) in order to impose restrictions on users for
sending further SMS messages.
Values
Generate accounting records: this is the recommended value

No accounting records

Accounting database Accounting documents - if enabled - are created in the configuration
database or another database. Either way, the database must be based on
the Sms4Domino template.
Specify the filepath, relative to the Domino data directory, where the
database resides. The database must be located on the same server as
the configuration database.
In this release accounting records must be created in the control database.
Values
leaving the field empty implies that the configuration database is used

for storing accounting records. This is the mandatory setting for the
current release.
filepath (e.g. Sms4Domino\accounting.nsf) to specify a dedicated

database
Proxy settings Clickatell gateways are based on standard HTTP(S) . Direct HTTP(S)