Installation guide

Sms4Domino Help
- 54 -
Sms
SmsSms
Sms4
44
4Domino Server Settings
Domino Server SettingsDomino Server Settings
Domino Server Settings
This section contains global settings that are used by the Sms4Domino instance.
Parameter
ParameterParameter
Parameter Purpose
PurposePurpose
Purpose
Autostart server When Sms4Domino is launched, either as an addin or as a standalone
program, it is ready to accept console commands. (The Help command
displays a list of available commands). However the Sms server is not yet
started by default. This allows the administrator to launch some test
probes on the modems.
By setting the Autostart server parameter to enabled the Sms server is
started automatically as soon as Sms4Domino is launched. In production
environments this should be the normal mode of operations.
Values
Enabled: this is the recommended value

Disabled

Delete messages from
GSM modem
GSM modems may keep a list of all outbound SMS messages in their
internal memory. When this memory is full the modem may refuse to
accept further messages.
Sms4Domino may delete the Sms from the memory of the modem after
transmission.
Values
Enabled: this is the recommended value

Disabled. The same message will be received multiple times from the

modem.
Outbound polling interval The outbound direction is defined as from Sms4Domino to the GSM
network
;
Requests for sending SMS messages may come from different sources.
Every source is implemented by an interface. The interface places the
request into an internal queue. Sms4Domino polls the queue every
outbound interval seconds.
Interfaces may accelerate the polling process by sending a signal to the
polling process. As a consequence it is allowed to have a rather large
outbound polling interval.
Recommended value: 300 seconds
Outbound queue depth Sms4Domino pushes outbound SMS requests into the queues managed by
SmsLib. This parameter specifies how many outbound requests may be at
any time in the SmsLib queues. In order to have an optimal throughput the
queue should not be left empty when there are still outbound SMS requests
present within the interfaces.
Pushing too many requests into SmsLib may result in a memory overload.
In case of a server crash the messages will be pushed again into the
queue when Sms4Domino starts again.
Recommended value: 2 * the number of outbound modems (outbound
gateways)
No inbound route found These settings specify how inbound SMS messages (received from GSM
network) are processed in case no or multiple matching inbound routing
documents have been found.
The received SMS may be forwarded by mail to 0, 1 or more valid mail
