Installation guide

Sms4Domino Help
- 34 -
COM Type Selection: RS232
Click the Save button to save the settings.
Test the connection
We assume the modem has already been configured. Connect the modem to the COM port of
the serial server.
Open a Dos box and enter the command (assuming the serial server is configured for IP address
10.0.50.100 and to listen on port 4660)
telnet 10.0.50.100 4660
The Dos window is cleared. Type AT. The modem should respond with OK
After the configured idle time the connection is closed automatically .
The same test could be performed using Putty. The connection type must be set to Raw.