Installation guide

Sms4Domino Help
- 33 -
Sms4Domino supports TCP/IP connected modems. There is no need for special driver software
that must be installed in Windows.
The serial server must be configured with following settings
TCP Server
Enable VirtualCOM for Serial/IP: No
Pair Connection: No
Reverse Telnet Mode: No
Local Listening Port: 4660 or any other value. The same value must be specified in the
Sms4Domino gateway definition document
IP filter: this is a security feature. Only the Sms4Domino server should be allowed to
communicate with the serial server.
Enabled: Yes
Source IP: specify the IP address of the Sms4Domino server
Idle Time before sending TCP Alive packet: Sms4Domino assumes the TCP/IP connection
remains open. Enter 2 for 20 seconds
TCP Inactivity Time: in case of a failure of Sms4Domino the connection should be broken.
Specify 60. This value should be higher than the watchdog interval specified in the
application profile (SmsLib settings)
Following set of parameters correspond to the physical COM interface. The settings must be the
same as the ones that have been configured in the modem.
Alias Name: for your own documentation
Baud rate: 57 600 (this is the default for the Cinterion modem)
Parity: none. (this is the default for the Cinterion modem)
Data bits: 8. (this is the default for the Cinterion modem)
Stop bits: 1 bit. (this is the default for the Cinterion modem)
Flow control: RTC/CTS (this is the default for the Cinterion modem)
Empty Serial Buffer: Yes
Data Packet Delimiter: this parameters determines at what moment data received from the
modem should be transmitted to Sms4Domino. There is no fixed terminator character that
applies to all responses. The only acceptable data packet delimiter is based on the
inter-character time gap. A value of 15 msec should be fine.