Installation guide

Sms4Domino Help
- 28 -
Configuration of the ATOP SE
Configuration of the ATOP SEConfiguration of the ATOP SE
Configuration of the ATOP SE 5000
50005000
5000 Serial server
Serial serverSerial server
Serial server
In case no COM ports are available or when the GSM modem should be located outside the
computer room it possible to connect the modem to a serial server. This device acts as a gateway
between the Ethernet LAN and the COM modems. The configuration of the serial server is
documented in the user guide.
The current help document guides you through the setup. Following steps must be executed
Connect the serial server to the LAN

Assign a fixed IP address to the serial server

Configure the serial server

Save the settings

Test the setup via a Telnet connection

Connect the serial server to the LAN
The serial server has following factory settings
IP address: 10.0.50.100
Subnet mask: 255.255.0.0
Default gateway: 10.0.0.254
DHCP client: disabled
User name: admin
Password: <null> (leave the password field blank)
Use a paperclip to push the reset button for a few seconds. You will hear some beeps. This
resets the serial server to the factory default settings.
Configure the Ethernet port of your (test) computer with compatible IP settings. E.g.