User`s manual

Quick Start Guide Version 1.3
SE5001 Ethernet Serial Server
Copyright © 2006 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
2
LED Indicators:
LAN LED
Message Description
Off
Ethernet Disconnected
Blinking with Green
Data is transmitting on Ethernet for 100Mbps
Blinking with Orange
Data is transmitting on Ethernet for 10Mbps
Table 1. LAN LED Message
COM Port LED
Message Description
Off
No data is transmitting on COM port
Blinking
Data is transmitting on COM port
Table 2. COM Port LED Message
RUN LED
Message Description
On Jumper JP1 Pin1 and Pin2 are shorted to disable
AP firmware running
Blinking (rate: 0.5 Sec) AP firmware is running normally
Table 3. RUN LED Message
Installation Procedures:
Step 1
: Connect SE5001 to power source using 5V DC Jack
(or 9~30V DC Terminal Block power source)
Note
: SE5001 provide two power inputs can be connected simultaneously to live DC power
sources. Anyone of the power inputs fails, the other live source acts as a backup to support
power needs automatically. The redundant dual DC power inputs give you extra assurance of
non-stop operation
Step 2
: Connect SE5001 to ones Ethernet network. Use a standard straight-through Ethernet cable
when one connect it to a hub/switch, one also can connect it to ones PC‘s Ethernet port via a
cross-over Ethernet cable for easy set up. However, in this case one need to make sure ones
PC is in the same network sub-net as SE5001.
Step 3
: Connect SE5001’s serial port to a serial device.
Step 4
: Placement options. One can mount SE5001 to a wall/panel (Mounting screws included) or
Din-Rail rack (Require optional item model: Din-Rail-Kit DK-25).
3. Software Setup
Default Network Setting: Default User Name/Password:
IP: 10.0.50.100 User Name: admin
Gateway: 10.0.0.254 Password: null (leave it blank)
Subnet: 255.255.0.0
Auto IP (Dynamic IP):
A DHCP server can automatically assigns the IP address and network settings. SE5001 supports the
DHCP function. By default, the DHCP function on SE5001 is disabled; you can use Monitor.exe to
enable this function. (ref Figure 3.1)
刪除: 1
刪除: putting a check on
Auto IP on Dialog window.