User`s manual

User Manual Version 1.4

SE5001 Ethernet Serial Server

4.2.2 Run Serial/IP for Atop on PC

In the Window Start Menu, go to “Programs”, select “Serial/IP for ATOP” and select “Control Panel”. When

“Select Port” windows pop-up, please select the serial port one want to configure. Then the configuration

window will appear. (Figure 4.4)

Figure 4.4 Serial/IP for Atop configuration

At the right side of Figure 4.4 is a sample Virtual COM Control Panel window. At the left side is the list of the

COM ports that one have selected (in the Select Ports window) for use by the Virtual COM Redirector. If

one wish to change which ports appear in this list, use the Select Ports button.

Each COM port has its own settings. When one click on a COM port, the Control Panel display changes to

reflect the settings for that COM port.

Note: When one change settings for a COM port, the changes are effective immediately. There is no

separate confirmation dialog to confirm or cancel ones changes.

4.3 Configuring Virtual COM Ports

One configure each Serial/IP COM port as follows: (Figure 4.5)

1. Select a COM port in the list.

2. For IP Address of Server, enter a numeric IP address for the serial server.

3. For Port Number, enter the TCP port number that the serial server uses to provide its serial ports

to the network.