User`s manual

User Manual Version 1.4
SE5001 Ethernet Serial Server
Copyright © 2006 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
32
4.1.4 Installation
Make sure one have turned off all anti-virus software before beginning the installation. Run the Virtual COM
setup file included in the CD to install Virtual COM driver for ones operating system.
In the end of the installation, please select one or two COM ports to become the Virtual COM ports.
4.1.5 Uninstalling
1. From Windows Start menu select Setting, Control Panel, Add/Remove Programs.
2. Select Serial IP for ATOP in the list of installed software.
3. Click the Add/Remove button to remove the program, or From Windows Start menu select
Programs, Serial IP for ATOP, Uninstall Serial IP for ATOP to remove the program.
4.2 Virtual COM Communication
4.2.1 Enable Virtual COM on SE5001
From web browser access to SE5001 by typing its IP address, click on COM1 link to access COM1 page, on
the top half of the page click on “TCP Server” and enable Virtual COM by putting a check in front of the
“Enable” button, then type in the local port number in the “Local Port” field as indicated in the following figure:
(Figure 4.2)
Figure 4.2 Enable Virtual Com
Or one can enable Virtual COM through telnet configuration by setting COM1 as TCP server, and type in the
local port number for COM1, then enable virtual COM as shown in the following figure: (Figure 4.3)