User`s manual

User Manual Version 1.4

SE5001 Ethernet Serial Server

3.2.7 COM Port Setting

Type 2 from “Input choice and enter (1~4):” of COM1, the following screen appears, one can then give the

COM port alias name, set the baud rate and parity, determine number of data bit and stop bit, and decide if

one want to use flow control and the type of flow control one want to use.( Figure 3.13)

Figure 3.13 Com port setting

3.2.8 Enabling Serial Data Buffer

Type 3 from “Input choice and enter (1~4):” of COM1, by default COM port serial data buffer is enabled

meaning that when TCP/IP Ethernet connection is broken, serial data collected from serial device will be

empty in SE5001 once TCP/IP connection is resumed, the serial data will be sent through Ethernet

connection, one can disable it if one wish.( Figure 3.14)

Figure 3.14 Com port-Enabling serial data buffer