User`s manual

User manual Version 1.1

ABLELink

Ethernet Serial Server SE5002

- 44 -

D.3 Configuring Devices

Use monitor.exe to configure the settings of devices on the network.

1. Repeat the steps in D.2 to bring up devices information.

2. Select the device to be configured from IP Address. Click on the “Config” button, a configuration dialog

box will popup as shown in Fig. 45:

Fig. 45. Configuration dialog box

3. After clicking on the “Configure Now” button, the target device returns an “ACK” message, indicating the

modification is successful as shown as follows:

The following table lists the functional description for each field.

Field Name Field Descriptions

Broadcast IP

Except for the default IP 255.255.255.255, other items (IPs) are read from the file

“seg.cfg”. This field specifies a detecting IP range. It may be a designated IP or a

broadcast IP.

Wishes

Specifies minimum number of the devices one wish to get reply from after sending

an Invite request. If there is not as many as devices responding to ones invitation,

the system repeatedly sends invitation until ones request is fulfilled.

Indicates the actual number of devices this utility program detected.

Retry

Specify the number of times that an Invite request is re-sent.

Locate

Locate the specified device.

Reset

Reset the selected device.

Config

Configure the selected device.

Exit

Exit this utility.