User`s manual

User manual Version 1.1

ABLELink

Ethernet Serial Server SE5002

- 24 -

Fig. 28. Com1 setup –pair connection

3.3.7 Configuring SE5002 in UDP mode：

SE5002 can be configured on a UDP mode to establish connection using unicast or broadcast data from the

serial device to one or multiple host computer. Vice versa is also true.

There are 2 UDP communication Modes：

1. Master (Client) Mode：To establish a connection using unicast or broadcast data from the serial device

to one or multiple host computer.

Note：The configuration is limited by Destination IP and Destination Port

Using broadcast data from a serial device to multiple host computers：For example, for destination IP

“10.255.255.255 “and destination port “4660”, the host computer’s IP addresses from

10.0.0.1~10.255.255.254 and listening Port at 666 can receive data sent from the serial device (Fig.

29)

Note：Broadcast IP address is limited by the Class of IP address and subnet mask. As an example, for

a network of Class C subnet 192.168.1.X and a subnet mask of 255.255.255.0,,one may configure the

broadcast IP address to be 192.168.1.255 (Fig. 31)