User`s manual

User manual Version 1.1

ABLELink

Ethernet Serial Server SE5002

- 20 -

Fig. 24. Change the password

2. Enter the old password on “Old Password” field; enter the new password on “New Password” and the

“Verified Password” fields, and then click on “Save Configuration” to update the password.

Note: One may press the reset key on the product to reset password to the default value.

3.3.3 Networking

Click on “Networking” link and the following screen (Fig. 25) shall appear. Fill in IP information on the

TCP/IP field. Alternatively, click on DHCP to obtain auto IP address, gateway and subnet mask.

Enable SNMP by checking “Enable”; fill in network identification information on SNMP and click on the “Save

Configuration” button to save the changes. The changes will not become effective until SE5002 is restarted

(Fig. 25)

Fig. 25. Network setup

3.3.4 Configuring SE5002 as TCP server：

SE5002 is configured in a transparent mode by default (Fig. 26)