User`s manual

User manual Version 1.0

ABLELink

SW5001 Wireless Serial Server

3.4. Hardware Installation Procedures：

 Prepare necessary cables, hub, power cord and RS-232/RS-485 connector.

 Place SW to the area that an access point can cover, or connect it via Ethernet cable with RJ45

connector.

 Connect SW’s serial port to a serial server; make sure the connector of RS-232 or RS-485 is correct.

 Plug in SW to DC-9-30V power source (Or to a 9~30V DC Terminal Block, the buzzer will beep and the

RUN LED will blink if SW’s functions normally. LED Status sees Appendix A.4.

 Use monitor.exe configuration utility on the product CD to check the status of SW. If it starts up

successfully, one shall find the IP and MAC addresses of SW. One may change IP address, gateway IP

address and subnet mask networking parameters of SW to join your LAN.

Note: If there are more than one access points, the access point’s SSID shall the same.

3.5. Default Setiings

The SW default settings are shown in the following table:

Property Default Value

Ethernet Port

IP Address 10.0.50.100

Gateway 10.0.0.254

Subnet Mask 255.255.0.0

WLAN Port

IP Address 192.168.1.100

Gateway 192.168.1.254

Subnet Mask 255.255.255.0

Security

User Name admin

Password Null(Leave it blank)

Serial

COM 9600,None, 8, 1, No flow control, buffer disabled, packet delimiter timer 1ms

Link Mode Type: TCP Server, Listen port 4660, Filter=0.0.0.0, Virtual COM disabled

SNMP

SysName of SNMP name

SysLocation of SNMP location

SysContact of SNMP contact

NOTE: Press reset button for 5 seconds to the default settings.