User`s manual

User manual Version 1.0

ABLELink

SW5001 Wireless Serial Server

This mode can be used to extend the normal serial communication distance of 15 m to 100 m or longer.

SW can be configured to the TCP Server Mode and waits for the host computer to establish a connection

with a serial device (the client). After the connection is established, data can flow in both directions (also

see Chapter 錯誤! 找不到參照來源。錯誤! 找不到參照來源。) , and hence enables two or more serial

devices to communicate with one another over IP network.

TCP –Server & Client

One may establish a connection between a TCP Server and a TCP Client for Master /Slave PLCs or other

serial devices.

Fig. 5. TCP Link in Tunneling mode

Configuring SE Series to Tunneling Mode

Using one of the four configuration methods (Telnet, Web, console and LCM controller), one may configure

SW to TCP Server mode with a listening 4660 port, and with other serial servers configured as TCP

Clients

Tip：TCP server shall assign the destination IP and the destination port corresponding to TCP client’s

listening port (example: TCP 4660 port).