User manual User guide
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Getting Started
- 4 LCM Configuration
- 5 Web Configuration
- 6 CLI Configuration
- 7 Link Modes and Applications
- 7.1 Link Mode Configuration
- 7.2 Link Mode Applications
- 7.2.1 TCP Server Application: Enable Virtual COM
- 7.2.2 TCP Server Application: Enable RFC 2217
- 7.2.3 TCP Client Application: Enable Virtual COM
- 7.2.4 TCP Client Application: Enable RFC 2217
- 7.2.5 TCP Server Application: Configure SE5416A Series as a Pair Connection Master
- 7.2.6 TCP Client Application: Configure SE5416A Series as a Pair Connection Slave
- 7.2.7 TCP Server Application: Enable Reverse Telnet
- 7.2.8 UDP Application: Multi-Point Pair Connection
- 7.2.9 TCP Server Application: Multiple TCP Connections
- 7.2.10 TCP Server Application: Multi-Point TCP Pair Connections
- 8 VCOM Installation & Troubleshooting
- 9 Specifications
- 10 Upgrade System Firmware
- 11 Warranty
Atop Industrial Serial Device Server
SE5408A/SE5416A Series
User Manual V 1.0
66
Operation: Main [6]COM Port Setting[1-4]Select Port[2]Com Settings
Figure 6.15
6.7 Alert Settings
There are two sub-menu settings included inside the Alert Settings, which are E-mail Settings
and Alert Event.
Figure 6.16
6.7.1 Configuring E-mail
When an alert event triggered, SE5416A Series can send that event through email. Here you
can configure Sender’s Email Address, Receiver’s Email Address (up to 5), Mail Server,
and Require Authentication.
Operation: Main [7]Alert Settings[1]E-mail Settings