User manual User guide
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Getting Started
- 4 LCM Configuration
- 5 Web Configuration
- 6 CLI Configuration
- 7 Link Modes and Applications
- 7.1 Link Mode Configuration
- 7.2 Link Mode Applications
- 7.2.1 TCP Server Application: Enable Virtual COM
- 7.2.2 TCP Server Application: Enable RFC 2217
- 7.2.3 TCP Client Application: Enable Virtual COM
- 7.2.4 TCP Client Application: Enable RFC 2217
- 7.2.5 TCP Server Application: Configure SE5416A Series as a Pair Connection Master
- 7.2.6 TCP Client Application: Configure SE5416A Series as a Pair Connection Slave
- 7.2.7 TCP Server Application: Enable Reverse Telnet
- 7.2.8 UDP Application: Multi-Point Pair Connection
- 7.2.9 TCP Server Application: Multiple TCP Connections
- 7.2.10 TCP Server Application: Multi-Point TCP Pair Connections
- 8 VCOM Installation & Troubleshooting
- 9 Specifications
- 10 Upgrade System Firmware
- 11 Warranty
Atop Industrial Serial Device Server
SE5408A/SE5416A Series
User Manual V 1.0
60
Note: It is not possible to configure LAN1 or LAN2 when bridge mode is enabled. Please go to
the Bridge Settings instead.
6.5.2 DNS Settings
You can configure the DNS1 or DNS2 Server IP Address manually. Alternatively, if you enable
the DHCP option in “LAN 1 Settings”, SE5416A Series will retrieve the DNS server address
from the DHCP server automatically.
Operation: Main → [2]Networking → [3]DNS Settings
Figure 6.6
6.5.3 SNMP Settings
SE5416A Series allows the user to Enable or Disable the SNMP function. The changes will
become effective immediately. Basic SNMP configurations such as Read/Write Community,
SysName (System Name), SysLocation (System Location), SysContact (System Contact),
and SNMP Trap Server IP are supported.
Operation: Main → [2]Networking → [5]SNMP Settings