User manual User guide
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Getting Started
- 4 LCM Configuration
- 5 Web Configuration
- 6 CLI Configuration
- 7 Link Modes and Applications
- 7.1 Link Mode Configuration
- 7.2 Link Mode Applications
- 7.2.1 TCP Server Application: Enable Virtual COM
- 7.2.2 TCP Server Application: Enable RFC 2217
- 7.2.3 TCP Client Application: Enable Virtual COM
- 7.2.4 TCP Client Application: Enable RFC 2217
- 7.2.5 TCP Server Application: Configure SE5416A Series as a Pair Connection Master
- 7.2.6 TCP Client Application: Configure SE5416A Series as a Pair Connection Slave
- 7.2.7 TCP Server Application: Enable Reverse Telnet
- 7.2.8 UDP Application: Multi-Point Pair Connection
- 7.2.9 TCP Server Application: Multiple TCP Connections
- 7.2.10 TCP Server Application: Multi-Point TCP Pair Connections
- 8 VCOM Installation & Troubleshooting
- 9 Specifications
- 10 Upgrade System Firmware
- 11 Warranty
Atop Industrial Serial Device Server
SE5408A/SE5416A Series
User Manual V 1.0
20
4.2.3 Serial Settings
1
st
layer
2
nd
layer
3rd layer
4
th
layer
5
th
layer
Descriptions
3.Serial set
1.Select port
Select a COM Port to
configure
2.Parameter
set
1.Baud Rate
1. 300
Display/Change baud rate
2. 600
3. 1200
4. 2400
5. 4800
6. 9600
7. 19200
8. 38400
9. 57600
10. 115200
11. 230400
12. 460800
13. 921600
2.Parity
1. None
Display/Change Parity
2. Odd
3. Even
4. Mark
5.Space
3.Data bits
1. 5 bits
Display/Change Data bit
2. 6 bits
3. 7 bits
4. 8 bits
4.Stop bits
1. 1 bits
Display/Change Stop bit
2. 2 bits