User manual User guide
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Getting Started
- 4 LCM Configuration
- 5 Web Configuration
- 6 CLI Configuration
- 7 Link Modes and Applications
- 7.1 Link Mode Configuration
- 7.2 Link Mode Applications
- 7.2.1 TCP Server Application: Enable Virtual COM
- 7.2.2 TCP Server Application: Enable RFC 2217
- 7.2.3 TCP Client Application: Enable Virtual COM
- 7.2.4 TCP Client Application: Enable RFC 2217
- 7.2.5 TCP Server Application: Configure SE5416A Series as a Pair Connection Master
- 7.2.6 TCP Client Application: Configure SE5416A Series as a Pair Connection Slave
- 7.2.7 TCP Server Application: Enable Reverse Telnet
- 7.2.8 UDP Application: Multi-Point Pair Connection
- 7.2.9 TCP Server Application: Multiple TCP Connections
- 7.2.10 TCP Server Application: Multi-Point TCP Pair Connections
- 8 VCOM Installation & Troubleshooting
- 9 Specifications
- 10 Upgrade System Firmware
- 11 Warranty
Atop Industrial Serial Device Server
SE5408A/SE5416A Series
User Manual V 1.0
19
4.2.1 Overview
1
st
layer
2
nd
layer
3rd layer
4
th
layer
5
th
layer
Descriptions
1.Overview
1.Model name
Display Model name
2.Kernel ver.
Display kernel version
3. AP ver.
Display AP version
4.Lan 1
1.Lan status
Display LAN1 status
2.MAC
Display MAC address of
LAN1
5.Lan 2
1.Lan status
Display LAN2 status
2.MAC
Display MAC address of
LAN2
4.2.2 Network Settings
1
st
layer
2
nd
layer
3rd layer
4
th
layer
5
th
layer
Descriptions
2.Network set
1.Lan 1
1.IP config
1.Static IP
Change to Static IP mode
2.DHCP
Chang to DHCP mode
2.IP address
Display/Change LAN1 IP
3.Net mask
Display/Change Net mask
4.Gateway
Display/Change the
Gateway IP
2.Lan 2
1.IP config
1.Static IP
Change to Static IP mode
2.DHCP
Chang to DHCP mode
2.IP address
Display/Change LAN2 IP
3.Net mask
Display/Change Net mask
4.Gateway
Display/Change Gateway
IP
3.DNS server1
Display/ Change DNS
Server 1 IP address
4.DNS server2
Display/ Change DNS
Server 2 IP address