User manual User guide
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Getting Started
- 4 LCM Configuration
- 5 Web Configuration
- 6 CLI Configuration
- 7 Link Modes and Applications
- 7.1 Link Mode Configuration
- 7.2 Link Mode Applications
- 7.2.1 TCP Server Application: Enable Virtual COM
- 7.2.2 TCP Server Application: Enable RFC 2217
- 7.2.3 TCP Client Application: Enable Virtual COM
- 7.2.4 TCP Client Application: Enable RFC 2217
- 7.2.5 TCP Server Application: Configure SE5416A Series as a Pair Connection Master
- 7.2.6 TCP Client Application: Configure SE5416A Series as a Pair Connection Slave
- 7.2.7 TCP Server Application: Enable Reverse Telnet
- 7.2.8 UDP Application: Multi-Point Pair Connection
- 7.2.9 TCP Server Application: Multiple TCP Connections
- 7.2.10 TCP Server Application: Multi-Point TCP Pair Connections
- 8 VCOM Installation & Troubleshooting
- 9 Specifications
- 10 Upgrade System Firmware
- 11 Warranty
Atop Industrial Serial Device Server
SE5408A/SE5416A Series
User Manual V 1.0
109
9.3.2 Serial and Female DB9 Connectors
RS-232
RS-485
RS-422
Pin 1
-
-
-
Pin 2
RXD
Data+
RX+
Pin 3
TXD
-
TX+
Pin 4
DTR
-
TX-
Pin 5
SG
SG
SG
Pin 6
DSR
Data-
RX-
Pin 7
RTS
-
-
Pin 8
CTS
-
-
Pin 9
-
-
-
9.3.3 Serial and Male DB9 Connectors
RS-232
RS-485
RS-422
Pin 1
-
-
-
Pin 2
RXD
Data+
RX+
Pin 3
TXD
-
TX+
Pin 4
DTR
-
TX-
Pin 5
SG
SG
SG
Pin 6
DSR
Data-
RX-
Pin 7
RTS
-
-
Pin 8
CTS
-
-
Pin 9
-
-
-
*This cable (RJ-45 to Male DB9) is included in the package.