User manual User guide
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Getting Started
- 4 LCM Configuration
- 5 Web Configuration
- 6 CLI Configuration
- 7 Link Modes and Applications
- 7.1 Link Mode Configuration
- 7.2 Link Mode Applications
- 7.2.1 TCP Server Application: Enable Virtual COM
- 7.2.2 TCP Server Application: Enable RFC 2217
- 7.2.3 TCP Client Application: Enable Virtual COM
- 7.2.4 TCP Client Application: Enable RFC 2217
- 7.2.5 TCP Server Application: Configure SE5416A Series as a Pair Connection Master
- 7.2.6 TCP Client Application: Configure SE5416A Series as a Pair Connection Slave
- 7.2.7 TCP Server Application: Enable Reverse Telnet
- 7.2.8 UDP Application: Multi-Point Pair Connection
- 7.2.9 TCP Server Application: Multiple TCP Connections
- 7.2.10 TCP Server Application: Multi-Point TCP Pair Connections
- 8 VCOM Installation & Troubleshooting
- 9 Specifications
- 10 Upgrade System Firmware
- 11 Warranty
Atop Industrial Serial Device Server
SE5408A/SE5416A Series
User Manual V 1.0
108
9.2 Software
Protocols
DHCP Client, DNS, ERPS, HTTP, ICMP, IPv4, NTP, RFC2217, SMTP, SNMP, STP,
Syslog, TCP, Telnet, UDP
Configuration
Serial Manager, Web UI, Serial console, Telnet
Virtual COM
Windows / Linux redirection software
Link Modes
TCP Server
4 connections, Virtual COM, or Reverse Telnet
TCP Client
Dual destinations or Virtual COM
UDP
Up to 8 ranges of IPs
9.3 Pin Assignments
9.3.1 Serial and RJ-45 Connectors
Ethernet
RS-232
RS-422
RS-485
Pin 1
Tx+
RTS
-
-
Pin 2
Tx-
DTR
TX-
-
Pin 3
Rx+
TXD
TX+
-
Pin 4
SG
SG
SG
Pin 5
SG
SG
SG
Pin 6
Rx-
RXD
RX+
Data+
Pin 7
DSR
RX-
Data-
Pin 8
CTS
-
-