Storm Series LCR Theater Speakers A83C/A53W www.atonhome.
Storm Series LCR Theater Speakers 1. Introduction Thank you for choosing ATON Storm Series LCR Theater Speakers. Available in ceiling-mount and in-wall configurations, each model was voiced in our sound labs by musicians with years of critical listening experience and crafted for your listening enjoyment. To see the complete line of ATON products, visit us online at www.atonhome.com.
Storm Series LCR Theater Speakers 2. System Design/Applications ATON LCR Theater Speakers are designed primarily to be installed in drywall ceilings and/or walls, but it is possible to install them in other materials. Prior to installation, it is essential to determine the type of application, and, therefore, the placement of the speakers. There are two typical applications that ATON LCR Theater Speakers will be used for: Home Theater and Stereo/ Critical Listening.
Storm Series LCR Theater Speakers TV A53W A53W A53W A82SW In-Wall Subwoofer 80 120 180 X O V E R A53W A53W Figure 2.2: Home Theater - All In-Wall Application TV A53W A53W A53W A82SW In-Wall Subwoofer 80 120 180 X O V E R A83C A83C Figure 2.3: Home Theater - Ceiling/In-Wall Application © 2007 • All rights reserved.
Storm Series LCR Theater Speakers Stereo/Critical Listening In areas that have a defined listening area where two speakers will be mounted more or less equidistant from each other, use a stereo setup with left and right speakers each connected to their own channel of a stereo receiver or amplifier. This application provides the best sound quality, staging, and depth possible in areas with a defined listening position. Figure 2.4 shows an example of a stereo listening area utilizing A83C Ceiling Speakers.
Storm Series LCR Theater Speakers 3. Installation The Installation process is divided into three distinct processes: Wiring, Mounting and Setting Switches. After carefully considering the intended application (Defining a Listening Area, Stereo/Critcal Listening, Home Theater, etc.), specific mounting locations can be decided upon. Once the specific locations are determined, installation can commence.
Storm Series LCR Theater Speakers • Two separate 2 conductor speaker wires run from the A/V Receiver or amplifier to each stereo speaker. A/V Receiver/Amplifier + + + + - - - - Figure 3.3: Wiring: Amplifier to Speakers - 2 Conductor Direct • One 4-conductor speaker wire runs from the amplifier to a splice near one speaker. A 2-conductor wire runs from the splice to each speaker. A/V Receiver/Amplifier Splice 4 Conductor Wire + + + + - - 2 Conductor Wire - - Figure 3.
Storm Series LCR Theater Speakers Pre-Wiring The audio/speaker cable runs should be routed from the head-end location to the speaker rough-in brackets (if used). At the speaker locations, securely fasten the speaker wire to the speaker rough-in bracket. If not using speaker rough-in brackets, staple speaker wire runs in a loose zigzag between the studs where the speaker is to be mounted to make it easier to find the cable after the drywall is installed.
Storm Series LCR Theater Speakers Mounting Two situations that can exist when mounting ceiling and in-wall speakers: • Pre-Construction - Installations that occur in new homes being built and in remodel situations where walls and/or ceilings will be exposed. • Retro-Fit - Installation that involve existing homes with walls and ceilings finished. While the end result of either type of installation is similar, the process is quite different.
Storm Series LCR Theater Speakers Mounting Rough-In Brackets Once the mounting locations are decided upon, assemble the brackets and secure them to the ceiling joists or wall studs using flat-head screws or heavy-duty staples (see the ATON Ceiling/InWall Rough-In Brackets Manual for detailed steps). Retro-Fit Retro-fit installations are more difficult to complete than pre-construction because walls and ceilings are intact. Typically wires must be fished into position through walls, floors and ceilings.
Storm Series LCR Theater Speakers Mounting Speakers in Ceiling (Pre-Construction or Retro-Fit) 1. Remove speaker grille and place speaker face down. 2. Locate the speaker wire and pull through the ceiling opening. 3. Connect the speaker wire. BE SURE TO OBSERVE CORRECT POLARITY! 4. Insert the speaker into the opening in the ceiling (or Rough-in Bracket opening) and carefully tighten each of the four clamping screws, alternating diagonally between each screw position to ensure proper fit. 5.
Storm Series LCR Theater Speakers Pointing the Mid-Range Once the audio system is connected and the speakers have been completely installed (with the grilles off), it is time to point the mid-range driver at the listening area. 1. Ensure that the LOCK screw located on the speaker baffle is loosened by turning it counter-clockwise. See Figure 3.12. LOCK Screw Figure 3.12: LOCK Screw 2. Twist the speaker baffle so that the angled mid-range driver is pointing in the desired direction.
Storm Series LCR Theater Speakers Mounting Speakers in Wall (Pre-Construction or Retro-Fit) 1. Remove speaker grille and place speaker face down. 2. Locate the speaker wire and pull through the wall opening. 3. Connect the speaker wire. BE SURE TO OBSERVE CORRECT POLARITY! 4. Insert the speaker into the opening in the wall (or Rough-in Bracket opening) and carefully tighten each of the six clamping screws, alternating diagonally between each screw position to ensure proper fit. 5.
Storm Series LCR Theater Speakers 4. Specifications A83C System Type........................................................................................................................................................... 3-Way Ceiling Woofer................................................................................................................................................................. 8" Woven Kevlar Midrange .................................................................................
Storm Series LCR Theater Speakers Notes: 14 ©2007 • All rights reserved.
Storm Series LCR Theater Speakers Notes: © 2007 • All rights reserved.
Storm Series LCR Theater Speakers Notes: 16 ©2007 • All rights reserved.
Limited Lifetime Warranty ATON warrants to the purchaser/end user (“you”) that all Storm Series Speakers are to be free from defects in materials and workmanship. This warranty is transferable to subsequent owners of the product as long as the original proof of purchase is retained. If you discover a defect in material or workmanship, you can obtain warranty service by contacting ATON at (859)-4227137 or service@atonhome.com.
