User manual

97
Configuring the system settings
Gigaset DX600A isdn / Swisscom EN / A31008-N3101-F151-1-7619 / settings.fm / 20.05.2010
Version 4, 16.09.2005
Prerequisite:
The desktop phone is in idle status i.e.,
u no calls are being made.
u There is no internal connection to/
between the registered handsets.
u No handset has the desktop phone menu
open.
Starting the firmware update
manually
v ¢
Ï
Settings ¢ System
Update Firmware
Select and press
§OK§.
~ Enter the system PIN and
press
§OK§.
The desktop phone establishes a connection
to the Internet.
§Yes§ Press the display key to start the
firmware update.
Automatic firmware update
Your desktop phone will check daily
whether a newer firmware update is availa-
ble from the Internet on the Gigaset config-
uration server. If firmware updates are avail-
able, the notification New firmware availa-
ble. Update? is displayed on the idle display
of the desktop phone.
§Yes§ Press the display key to confirm
the prompt.
The firmware is loaded onto your desktop
phone.
You can deactivate the automatic version
check via the Web configurator.
Activating repeater support
You can increase the range and signal
strength of your desktop phone using a
repeater. You will need to activate repeater
mode. This will terminate any calls that are in
progress at the time.
Prerequisite: Eco mode(+) is deactivated.
v
¢
Ï
¢ System ¢ Repeater Mode
§Change§ Press the display key to activate
or deactivate repeater mode
(³= on).
§Yes§ Press the display key to confirm
the prompt.
Activating/deactivating the
DECT interface
If you deactivate the DECT interface, the
radio connection between the desktop
phone and the registered handsets/repeat-
ers is terminated. Handsets/repeaters are
"asynchronous" to the desktop phone. They
cannot establish a connection with the desk-
top phone and no calls are signalled. Hand-
sets/repeaters do remain registered to the
desktop phone and will synchronise with
the desktop phone as soon as you reactivate
the DECT interface.
Please note
u The firmware update can take up to
3 minutes.
u When updating from the Internet,
checks are made to ensure that no
newer version of the firmware exists.
If this is not the case, the operation is
terminated and a message is issued to
that effect.
Please note
If the desktop phone is not connected to
the Internet at the time when the check
for new firmware is to be carried out (e.g.,
because the router is deactivated), the
check is carried out as soon as the desk-
top phone is reconnected to the Internet.
Please note
Repeater support and Eco/Eco+ mode
(
¢ page 75) cancel each other out i.e.,
both functions cannot be used at the
same time.