User manual

94
Configuring the system settings
Gigaset DX600A isdn / Swisscom EN / A31008-N3101-F151-1-7619 / settings.fm / 20.05.2010
Version 4, 16.09.2005
Setting your own area code
To transfer phone numbers (e.g., in vCards),
it is essential that your area code (interna-
tional and local area code) is saved on the
desktop phone.
Some of these numbers are already preset.
v
¢
Ï
Settings
¢ Telephony
¢ Area Codes
Check that the (pre)set area code is correct.
¤ You can enter data in the following fields:
q Select/change input field.
r Navigate in the input field.
Ñ If necessary, delete number:
Press the display key.
~ Enter number.
§Save§ Press the display key.
Example:
Setting the desktop phone's
IP address in LAN
Prerequisite: Your desktop phone is con-
nected to a router or a PC (
¢ page 14).
An IP address is required in order for the LAN
to "recognise" your desktop phone.
The IP address can be assigned to the desk-
top phone automatically (by the router) or
manually.
u If done dynamically, the router's DHCP
server automatically assigns an IP
address to the desktop phone. The desk-
top phone's IP address can be changed
according to router settings.
u If done manually/statically, you assign a
static IP address to the desktop phone.
This may be necessary depending on
your network configuration (e.g., if your
desktop phone is connected directly to a
PC).
You can also make local network settings via
the Web configurator.
v
¢ Ï Settings ¢ System
¢ Local Network
~ Enter the system PIN and
press
§OK§.
¤ You can enter data in the following fields:
IP Address Type
Select Static or Dynamic.
For IP Address Type Dynamic:
The following fields show the current set-
tings that the phone obtained from the
router. These settings cannot be
changed.
For IP Address Type Static:
You must manually define the IP address
and the subnet mask for the desktop
phone in the next lines, as well as the
standard gateway and DNS server.
IP Address
Enter the IP address that is to be assigned
to the desktop phone (overwriting the
current settings).
192.168.2.1 is the default.
Information on the IP address can be
found in the glossary on page 121.
Subnet Mask
Enter the subnet mask to be assigned to
the desktop phone (overwriting the cur-
rent settings).
The default setting is 255.255.255.0
Information about the IP address can be
found on page 124.
Area Codes
International code:
00 - 41
Local area code:
0 - [ ]
Û
Save
Please note
To assign the IP address dynamically, the
DHCP server on the router must be acti-
vated. Please also read the user guide for
your router.