User manual

81
Connecting/using other devices
Gigaset DX600A isdn / Swisscom EN / A31008-N3101-F151-1-7619 / HS_and_other_Devices.fm / 20.05.2010
Version 4, 16.09.2005
When the internal participant answers:
¤ If necessary, announce the external call.
& / T Replace the receiver or press the
end key.
The external call is transferred to the other
handset.
If the internal participant does not answer or
the line is busy, press the display key
§End§, to
return to the external call.
You can also replace the receiver before the
internal participant picks up when transfer-
ring the call.
Then, if the internal participant does not
answer or the line is busy, the call will auto-
matically return to you.
Initiating an Internal consultation/
conference
When you are conducting an external call,
you can call an internal participant at the
same time for consultation or hold a confer-
ence call between all three participants.
You are conducting an external call:
u Open the list of handsets.
The external participant hears
music on hold, if activated
(
¢ page 91).
s If more than one handset is reg-
istered: Select handset and
press
§OK§.
You are connected to the internal partici-
pant.
Either:
§Options§ ¢End Active Call
You are reconnected with the
external participant.
Or:
§Conf.§ Press the display key.
All 3 participants are connected
with each other.
If the internal participant does not answer:
¤ Press display key §End§ to return to the first
external caller.
Ending a conference
An internal participant pressing the end call
key (on the handset) or the end key T
does not affect the connection between the
other internal participant and the external
participant.
External call waiting during an
internal call
If you receive an external call during an
internal call, you will hear the call waiting
tone (short tone). The caller's number or
name will appear in the display if Calling
Line Identification is enabled.
Rejecting the external call
§Reject§ Press the display key.
The call waiting tone is turned off. You
remain connected with the internal partici-
pant. The external caller will hear the busy
tone.
Ending an internal call
& / T
Replace the receiver or press the
end key.
The external call is signalled as an incoming
call on the desktop phone. You can accept
the call (
¢ page 34):
Accepting an external call
§Accept§ Press the display key.
You are connected to the external caller.
The internal call is placed on hold.
You have the following options:
u Connect to both participants:
¤ Use q to swap between the partici-
pants.
u Speak to both participants at the same
time:
¤ Press display key §Conf.§ to establish
the conference call. Press display key
§EndConf§ to return to call swap mode.