User manual
18
Taking the first steps
Gigaset DX600A isdn / Swisscom EN / A31008-N3101-F151-1-7619 / starting.fm / 20.05.2010
Version 4, 16.09.2005
If the handset has been successfully registered on the desktop phone, you will see
the following display (approx. 3 seconds long):
Then "Register a handset?" is shown in the display again (¢page 17).
¤ Press the display key §Yes§, if you wish to register another handset and carry out
the steps listed above with this additional handset.
Press
§No§ to close the registration wizard and start the connection wizard.
3. Connection wizard
Using the connection wizard, you can assign the previously configured numbers
(ISDN MSNs,
¢ page 16) to internal parties (desktop phone, handsets and desktop
phone answering machines as well as any connected fax machine,
¢ page 86) as
send and receive connections, if necessary.
u Receive connections are numbers (MSNs) on which you can be called. You can
assign the MSNs for internal parties as the receive connection. Incoming calls are
only diverted to the terminals to which the relevant receive connection has
been assigned. Terminals are e.g., desktop phone, handsets or answering
machines or a connected fax machine.
u Send connections are the numbers (MSNs) that are sent to the called party.
The network provider calculates charges based on the send connections.
You can assign a fixed MSN as a send connection to each internal party.
u Every MSN can be both a send and receive connection. You can assign each MSN
to multiple handsets, the desktop phone and a connected fax machine as a send
and/or receive connection. It may only be assigned to an answering machine as
a receive connection.
Once a Aton handset has been success-
fully registered, it will change to idle
mode. The handset's internal name is
shown on the display (INT 2, INT 3 to
INT 7).
Please note
u By default, the desktop phone is assigned the internal name INT 1 and the
internal number 1.
u The desktop phone assigns the lowest free internal number to the handset
(possible numbers: 2–7). The handset's internal name is shown in the display
e.g., INT 2. This means that the handset has been assigned the internal
number 2.
u The internal numbers and names of all registered handsets can be changed
(
¢ page 79).
Registration
‰
Handset registered