User guide

54
Appendix
Aton CLT109 / Swisscom EN / A31008-M2007-F151-1-2X19 / appendix.fm / 04.02.2009
Version 4, 29.10.2007
Aton CLT110 only:
Approval
This device is intended for analogue tele-
phone connection in the Swiss network.
Country-specific requirements have been
taken into consideration.
Swisscom hereby declare that this device
meets the essential requirements and
other relevant regulations laid down in
Directive 1999/5/EC.
The Declaration of Conformity can be found on
the following website:
www.swisscom.ch
under the heading "Online Shop", Telephones,
Conformity Declaration.
Appendix
Care
Wipe the base station, charging cradle and
the handset with a damp cloth (do not use
solvent) or an antistatic cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
If the handset should come into contact
with liquid:
1. Turn the handset off and remove the
batteries immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours
(not in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Specifications
Recommended batteries
Technology:
Nickel-metal-hydride (NiMH)
Size: AAA (Micro, HR03)
Voltage: 1.2 V
Capacity: 550 – 1000 mAh
No time is specified for a message in the
answer machine history.
Date/time is not set.
¥ Set the date/time (¢ page 15).
The answer machine announces "PIN is
incorrect" during remote operation.
1
.
You have entered the wrong system PIN.
¥ Enter the system PIN again.
2
.
The system PIN is still set to 0000.
¥ Change the system PIN (¢page 49).
The answer machine will not record any
messages.
Its memory is full.
¥ Delete old messages.
¥ Play back new messages and delete.
!