User guide

50
Base station settings
Aton CLT109 / Swisscom EN / A31008-M2007-F151-1-2X19 / registr_sett.fm / 04.02.2009
Version 4, 29.10.2007
~ Enter the old system PIN and
press
§OK§. For security, the PIN
is shown as four stars (
****
).
~ Enter your new system PIN
and press
§OK§.
a Press and hold (idle status).
Resetting the system PIN
If you have forgotten the system PIN, you
can reset it to the original code 0000 by
resetting the base station to its default set-
tings. This will also reset every other
setting, see "Restoring the base station to
the factory settings"
¢ page 50.
Changing ringer tones
u Volume:
You can choose between five volumes
and the "crescendo" ring,
¢ page 48.
Select "0" to deactivate the base station
ringer.
u Ringer tones:
You can set a ringer melody for external
calls, ¢ page 48.
§Menu§ ¢ Settings ¢ Base ¢ Audio Settings
¢ Ringer Volume / Ringer Melody
For how to adjust the settings,
¢ page 48.
Repeater support
With a repeater you can increase the range
and reception strength of your base sta-
tion. You will need to activate repeater
mode. This will terminate any calls that
are in progress at the time.
Precondition: A repeater is registered.
The Eco Mode / Eco Mode Plus is deacti-
vated.
§Menu§ ¢ Settings ¢ Base
¢ Additional Features ¢ Repeater Mode
§Yes§ Press the display key.
When repeater mode is active, the menu
item is marked with .
Restoring the base station to the
factory settings
When restoring factory settings:
u Handsets are de-registered
– When resetting via the menu:
all handsets
– When resetting using the key on
the base station: also all handsets
of other GAP capable devices
u Individual settings are reset
u All lists are deleted
u The system PIN is reset to the original
code 0000
u Eco Mode plus is activated
Only the date and time are retained.
Resetting the base station via the
menu
§Menu§ ¢ Settings ¢ Base ¢ Base Reset
§OK§ Press the display key to
confirm.
Resetting the base station using a key
on the base station
¤ Disconnect the power cord from the
base station.
¤ Hold down the registration/paging key
(
¢ page 2) on the base station while
reconnecting the power cable to the
base station. Press and hold the key
until you hear a confirmation tone.
The base station has now been reset.
‰
Please note
Repeater support and Eco Mode / Eco
Mode Plus (
¢ page 43) cancel each
other out, i.e. both functions cannot
be used at the same time.