User guide

First steps

Aton CLT109 / Swisscom EN / A31008-M2007-F151-1-2X19 / starting.fm / 04.02.2009

Version 4, 29.10.2007

To charge the batteries, leave the handset in the charging cradle.

Should you have any questions and problems

¢ page 53.

Initial charging and discharging of batteries

The correct charge level can only be displayed if the batteries are first fully

charged and discharged.

Please note

u Each key press interrupts the automatic registration.

u If automatic registration does not work, the handset will have to be

registered manually (

¢ page 45).

Please note

Only place the handset in the base station or charging cradle that is

intended for it.

Please note

u After the first battery charge and discharge you may replace your hand-

set in its base station or charging cradle after every call.

u Always repeat the charging and discharging procedure if you remove the

batteries from the handset and reinsert them.

u The batteries may warm up during charging. This is not dangerous.

u After a while, the charge capacity of the batteries will decrease for

technical reasons.

¤ Place the handset in the base station or

charging cradle for eleven hours.

¤ Then remove the handset

from the base station or

charging cradle and do not

replace it until the batteries

are completely discharged.

11 h