User Manual

8
Diagram Exceed BLS 4s30A ESC Wiring /电调接线图
ESCInformation/电调说明
1.The ESC included with the model has a safe start.If the motor battery is
connected to the ESC and the throttle stick is not in the low throttle or off
position,the motor will not start untill the throttle stick is moved to the low
throttle or off position.
2.Power on the ESC(The ESC must connect to the motor and Receiver).
The motor will emit a series of beeps, after the beeps, set the the throttle
stick the the minimum, the motor will emit a series beep again. now the ESC
calibration is done.
1.电调具有安全启动设置，当电机、电池连接电调后，电调信号未处于最低位置，
电调输出不会启动。
2.电调油⻔校准：请先拆卸螺旋桨，将油⻔摇杆移动到最⾼位置后通电，当哔哔
声结束后，迅速将油⻔摇杆移动到最低位置，哔哔声⾳结束，油⻔校准成功。
100
+
-
G
5V
s
MOTOR
电源正负极，VCC/GND
5V3A输出，Output 5V3A
油⻔信号，Throttle
油⻔信号地，Throttle GND
Voltage input/电压输⼊范围: 2~4S Lipo
Continuous current/持续输出电流：30A
Max Current/最⼤电流: 35A
Output/输出：Built in 5V 3A BEC/内置5V 3A BEC
Throttle calibration /电调油⻔校准
29mm
18mm