User Manual Dolphin 海豚 www.atomrc.
Introduction/简介 The Dolphin is sweep forward fly wing, with elegant design, the dolphin can fly stable both on high speed and low speed, the large fuselage can give use lots of space to install the electronics, the detachable wing made the wing easy for transport, V tail made the wing more stable for crusing. 海豚是前掠式⻜翼布局⻜机，针对FPV⻜⾏所搭载的设备载重，极佳的优化了异形和装配空间。 能够满⾜⾼速⻜⾏的同时，低速也能获得⾮常优秀的滑翔性能。可拆卸的机翼使机翼便于运输， V型尾翼使机翼在巡航时更加稳定。 Specifications/规格 Specifi cations/规格 Wingspan/翼展: 845mm Length/⻓度: 710mm WingArea/翼⾯积: 15.
Version Description/版本说明 ATOMRC Dolphin V1.
KIT Foam Contents/KIT 泡沫配件 FA FB FER FCU FEL FCL FF FGR FD FGL FA:Front Hatch Cover 尖机头 FB:Gopro Cover Gopro机头 FCU:Upper Fuselage 上机身 FCL:Lower Fuselage 下机身 FD:Front Hatch 前舱盖 FER:Right Wing 右机翼 FEL:Left Wing 左机翼 FF:Rear Hatch 后舱盖 FGR:V Tail 右V尾 FGL:V Tail 左V尾 3
KIT/PNP Installation/安装指南 1 Install the motor and ESC. 安装电机电调。 2 Install the servo and push rods, then install the rudder. 将舵机安装到垂尾、平尾，居中调试后，安装拉杆。粘合左右垂尾。 3 User can choose carbon plate to install the camera or just use foam to fill. ⻜机机头位置，可以选择安装摄像头固定碳⽚或者泡沫填充。 4 Install the wing to the fuselage.
5 When Gopro is installed, adjust battery slider to adjust balance. 安装Gopro时，需要将电池安装到后⾯，通过滑块调平。 6 To install Gopro, use rubber band to lock the gopro then install the hatch. 若安装GOPRO，需⽤橡⽪筋固定住GOPRO，然后盖上机头相机盖。 7 Install the Nose and Cam. 安装摄像头机头。 8 CG CG The CG is marked under the wing, you can move the CG 3-4mm to get better control.
RTH/RTH FPV Installation/安装指南 1 Install the Camera mount plate, and the V taill. 安装机头相机安装⽚，粘接V尾。 2 Install the wing to the fuselage， Plug the Left Servo to S4, Right Servo to S4.
ATOMRC F405 NAVI Information/⻜控说明 GND GND GND Rx1 Rx2 Rx3 5V CL DA Tx3 Micro SD Card Slot VCC GND + ESC - 3~6S BAT 5V VTX+ 5V GND Tx4 Rx4 Tx4 5V GND 5V SBUS + F405 GND GND GND GND GND GND GND GND GND Tx5 Rx5 Rx5 Tx5 GND GND 5V 5V 5V 5V 5V 5V 5V 5V 5V S1 S2 S3 S4 S5 S6 S7 S8 LED SBUS GND 5V BAT 9V DP + SBUS IN 5V GND LED DJI AIR UNIT GNG GND 5V GPS SBUS GNG ATOMRC 5V SCL Beitian 5V DM - GND + S F405-NAVI BOOT BUZZ ON WS2812 LED Str
ESC Information/电调说明 Throttle calibration /电调油⻔校准 1.The ESC included with the model has a safe start.If the motor battery is connected to the ESC and the throttle stick is not in the low throttle or off position,the motor will not start untill the throttle stick is moved to the low throttle or off position. 2.Power on the ESC(The ESC must connect to the motor and Receiver).
VTX Tx15 User manual/图传说明书 Tx15 Wiring Diagram/ Tx15图传接线图 AUDIO VIDEO GND 5V OUT GND VCC VIDEO GND 5V Please make sure antenna is installed before power on, otherwise the VTX will fried!!! 图传发射机通电前务必确认天线已安装妥当，否则发射线会烧毁!!! Tx15 Specs /Tx15规格参数 Voltage input/电压输⼊范围: 2~6S Lipo Power/功率: 200/800/1500mw Switchable Power consumption/功耗: 9V 1.1A Frequency/频率:5.3~5.
