Owner`s manual
ATOMIC AMPS REACTOR 50/50 MANUAL
5
The Reactor 50/50 is easy to use and oers the controls needed for a great
range of music performance situaons. NOTE: Always lower the output
level knobs on any connected devices before beginning to operate the
power amp.
1. Connect one or more speakers to the Speaker Output Jacks and
set the Impedance Selector Switch to match their rang(s).
2. Using a high-quality cable, connect a signal source to either the
Unbalanced (¼”) Input or the Balanced (XLR) Input.
3. Connect the supplied Power Cable to your unit’s Power Input
located on the back panel.
4. Turn the Power Switch to ON. The power light should come on.
5. Wait at least 60 seconds for the amplier to warm up, then set the
Standby Switches to ON for ONE or BOTH channels.
IMPORTANT! Never take a Reactor 50/50 channel out of standby
when input signal is present and no speaker or load connected to
the speaker output. Doing so will damage the amplier.
6. Increase the level of your instrument or processor and set the
Master Level of the Reactor 50/50 to the desired level. Adjust the
tweeter level to taste.
WHO’S DRIVING? Whether you like to run your source signal “Hot” and
lower the master volume of the Reactor, or turn up the Reactor and lower
the output level of a connected instrument or processor, you will nd that
the Reactor operates quietly and sounds great.