Owner Manual

13
For Customer Service Call 1-888-996-2729
© 2016 Escalade Sports
All RIghts Reserved.
STEP 10
PARTS REQUIRED:
2 pcs - H3 M6 x 45 mm Allen Head Bolt 4 pcs - H10 Plastic Bushing
4 pcs - H6 M6 x 75 mm Allen Head Bolt 1 pc - P15 Long Support Tube
12 pcs - H7 Flat Washer 1 pc - P24 Ramp Chute
6 pcs - H9 Lock Nut 1 pc - T1 Allen Wrench
1 pc - T2 Wrench
Slide elastic loop and sleeve of P24 Ramp Chute onto the P1 - Upper Tube as shown in FIGURE 10
and DETAIL I.
Slide P13/14 Tube assembly into the front sleeve of P24 Ramp Chute as shown in FIGURE 10 and DETAIL J.
Attach P9/P12 , P10/P12 and P11/P12 assembly tubes from STEP 3 to P14 - Front U-Tubes using
H6 Bolts, H7 Flat Washers, H10 Plastic Bushings and H9 Lock Nuts as shown in FIGURE 10 and DETAIL K.
Note: This is a pivot point. “Snug” tighten H9 Nuts only.
Make sure this assembly pivots freely.
Place P15 Long Support Tube over the front sleeve of P24 Ramp Chute and attach to P14 - Front U-Tubes
using H3 Bolts, H7 Flat Washers and H9 Lock Nuts as shown in FIGURE 10 and DETAIL L.
Use T1 Allen Wrench and T2 Wrench
to tighten H4 Bolts & H9 Nuts.
Elastic
Loop
Ramp Chute
Upper Sleeve
DETAIL I
DETAIL J
Ramp Chute
Front Sleeve
P1
P24
DETAIL K
P13/P14 Assembly
P12
P12
H6
H7
H10
H7
H9
P13
P14
H10
H7
H9
H3
H7
H9
P14
DETAIL L
P24
FIGURE 10
H6
H7
NOTE: P12 tube
inside of P14
NOTE: P12 tube
outside of P14
Outside
Ramp stays under the
P15 Long Support Tube
P15 Inside
Inside