Owner Manual
Table Of Contents
11
For Customer Service Call 1-888-996-2729
© 2016 Escalade Sports
All RIghts Reserved.
STEP 7
PARTS REQUIRED:
4 pcs - H6 M6 x 75 mm Allen Head Bolt 4 pcs - H10 Plastic Bushing
6 pcs - H7 Flat Washer 2 pcs - P25 Locking Pin
4 pcs - H9 Lock Nut 1 pc - T1 Allen Wrench
1 pc - T2 Wrench
Attach P9/P12 assembly tube and P10/P12 assembly tube from STEP 3 to P8 - Front Upright Tubes using
H6 Bolts, P25 Locking Pins, H10 Plastic Bushings, H7 Flat Washers and H9 Lock Nuts as shown in
FIGURE 7, DETAIL G and DETAIL H.
Attach P11/P12 assembly tubes from STEP 3 to P8 - Front Upright Tubes using H6 Bolts, H7 Flat Washers,
H10 Plastic Bushing and H9 Lock Nuts as shown in FIGURE 7, DETAIL G and DETAIL H.
Note: This is a pivot point. “Snug” tighten H9 Nuts only. Make sure this assembly pivots freely.
FIGURE 7
DETAIL H
DETAIL G
Spring Lock
face inside
H6
H7
P25
H10
P11
P9
H7
H9
H9
H7
H10
P8
P12
P9
P11
P12
P10
P11
P8
P8
H9
H7
H10
P25
H6
H7
H10
H9
H7
P11
P10
P8
NOTE:
Use “bottom” hole
for this assembly.
NOTE:
Use “bottom” hole
for this assembly.
Inside
Outside
Outside
Inside
Inside
Outside