Owner Manual

FIGURE 3

STEP:3

Lift the table assembly from the floor with at least six strong adults, turn it over, and set

the table assembly on its legs in the location where you will play.

1 pc -

P6 Electronic Scorer

PARTS REQUIRED:

H4 3.5 x 18mm Phillips Round Head Screw 2 pcs -

CAUTION: Six strong adults are recommended to flip

the table as shown.

1. Grab the table on the ground.

2. Turn the table over.

3. Place it on all four feet at the same time onto the ground.

Junction Box (

C3)

tabs

Slots

NOTE:Make sure the tabs on

the plug are turned correctly

for correct installation.

Be careful to match the

plug “Tabs” with the

correct “Slots”.

Pilot Hole

First,feed the Electronic Scorer plug (P6) down through the hole on one side of the long top

rail as shown in FIGURE 3.

Next, connect the Electronic Scorer plug to the Junction Box (C3) as shown in DETAIL A.

Next, install Electronic Scorer (P6) onto long top rail using Philips Round Head Screws (H4)

and Pilot Holes as shown in FIGURE 3.

Tighten, but do not strip out Screws (H4).

DETAIL A